Insights

Convadis CCom: the new management interface

Convadis rebuilt its management interface in summer 2026. What changed – and when you as an operator actually need to look at it.

Roland Kainbacher – Porträt Roland Kainbacher 5 min
Convadis CCom – neue Verwaltungsoberfläche

Anyone running a sharing fleet on Convadis telematics works with two interfaces: Zemtu for everything to do with bookings, customers and billing – and CCom for the device in the vehicle. In summer 2026 Convadis rebuilt that second interface. Here is what changed, and when you actually need to look at it.

What CCom is

CCom is the Convadis management interface for the installed telematics units. It records which device sits in which vehicle, whether it has a connection and what it last reported. You do not need CCom for day-to-day sharing operations – that runs in Zemtu. It becomes relevant when a vehicle is added, when something stops responding, or when you want to check a technical value the booking platform does not display.

What is new

The new Convadis interface: vehicle list with status, odometer, charge level and door status
The vehicle list in the new interface – you decide which columns appear.

The revised interface is more clearly structured than its predecessor. Three things stand out in daily use:

  • The vehicle list is configurable. Under “Columns” you decide what you see: registration and VIN, odometer from the vehicle and from GPS, fuel or charge level, door and window status, immobiliser. If you only care about the charge level, hide the rest.
  • Searches can be saved. Filters by location, customer number or vehicle group do not have to be set up each time – once saved, they sit in the left-hand column.
  • List or map. The same selection can be shown as a table or on a map. For “where is that vehicle right now”, the map is the faster route.

The command stack is still there as well: send commands to several vehicles at once instead of handling each one individually. Useful when a whole group needs reinitialising after a fault.

Map view in Convadis CCom showing vehicle status, charge level and remote commands
Map view: the status of the selected vehicle on the right, with the commands that can be sent remotely below it.

The switch is gradual

The old interface remains available – a link at the bottom left of the new one leads there. Some specialist functions have not been carried over yet. For normal operation the new view is enough; if something seems to be missing, it is usually still in the old admin.

Zemtu or CCom?

The division of labour is straightforward:

  • In Zemtu you work with bookings, rates, user accounts, approvals, invoices and utilisation reports. Unlocking or locking a vehicle in a support case happens there too.
  • In CCom it is about the device: is the box online? What is it reporting? Are the vehicle details correct? Those questions mainly come up during commissioning and with technical faults.

The telematics values – odometer, fuel, charge level, door status – reach Zemtu through the interface anyway and are available with every booking. In normal operation the detour via CCom is not needed.

Route history of a trip in Convadis CCom with a charge level curve
The route history shows the distance covered, with one measured value plotted below – here the charge level over the day.

Access

CCom credentials are issued by Convadis, not by Zemtu. If you run your fleet with us and need your own access, get in touch – we will make the introduction and set up the connection so both systems know the same vehicles.